Snmpset and scripts

Hello everyone,
First, I want to say that I'm new to this area, so I'm sorry if I say
anything too vague or absurd.

In recent days I've been researching a way to use scripts with SNMP, for
example, what the "extend" module in snmpd.conf does. The problem is that
when I use "extend" I can not use the snmpset command in the script I want.
What I need is to pass a parameter that I want and run the script through
snmp with this parameter. But, I always get a "notWritable" error.

So I researched a bit and saw that some people had problems with snmpset,
also trying to use the "extend" module. In short, I wanted to ask if there
is any simple way to pass parameters through snmpset to scripts, or if I
need to create some MIB for this, I really do not know which way to go. I
would be grateful if there was also good documentation related.

Thanks for listening.

<https://www.avast.com/sig-email?utm_medium=email&utm_source=link&utm_campaign=sig-email&utm_content=webmail>
Livre
de vírus. www.avast.com
<https://www.avast.com/sig-email?utm_medium=email&utm_source=link&utm_campaign=sig-email&utm_content=webmail>.
<#DAB4FAD8-2DD7-40BB-A1B8-4E2AA1F9FDF2>

------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot

_______________________________________________
Net-snmp-users mailing list
[email protected]
Please see the following page to unsubscribe or change other options:
https://lists.sourceforge.net/lists/listinfo/net-snmp-users