Re: filter interfaces in snmp-get output

Thank yo for your reply. I just write oids in snmpd.conf and in
solarwinds it shows all of the interfaces yet. I think the solarwinds
get the output of the snmpget. How should I cjhange the oids to show
eth0-eth2 and not the others.

On 8/19/18, Ilya Etingof <[email protected]> wrote:
>
> May be get run `snmpget` against the select of interfaces you need? Just get
> them by the full OID e.g. including the trailing index part.
>
> $ snmpwalk -c public demo.snmplabs.com IF-MIB::ifName
> IF-MIB::ifName.1 = STRING: lo
> IF-MIB::ifName.2 = STRING: eth0
> IF-MIB::ifName.3 = STRING: eth1
> IF-MIB::ifName.4 = STRING: ppp0
>
> $ snmpget -c public demo.snmplabs.com IF-MIB::ifName.2 IF-MIB::ifName.4
> IF-MIB::ifName.2 = STRING: eth0
> IF-MIB::ifName.4 = STRING: ppp0
>
> You can include other columns of the interfaces table into the query.
>
>> On 19 Aug 2018, at 08:02, Fatemeh Mehdizadeh
>> <[email protected]> wrote:
>>
>> hi, I have interfaces eth0,eth1, eth2, pflog0 ,ipfw0 on my system.
>> when I want to see my intefaces with snmp-get, it shows all of
>> interfaces. I want to see just eth0 - eth2 and not the pflog and
>> ipfw0. How should I do this?
>>
>> Thanks all
>
>

------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Net-snmp-users mailing list
[email protected]
Please see the following page to unsubscribe or change other options:
https://lists.sourceforge.net/lists/listinfo/net-snmp-users