Re: netsnmp 5.7.1

yes netsnmp 5.7.1, does support v3 traps.



On Fri, Oct 26, 2018 at 3:30 PM LIU Chris (CA) <[email protected]>
wrote:

> I am using netsnmp 5.7.1, does it support v3 trap?
>
> From wireshark, it seems sending v2 trap
>
>
>
>
>
> With Best Regards,
>
>
>
> Chris LIU
>
>
> Thales Canada, Transportation Solutions
> 105 Moatfield Drive
> Toronto, Ontario
> Canada, M3B 0A4
> http://www.thalesgroup.com
> Tel: +1 416 748 4424 ext. 4015237
>
> Email: [email protected]
>
>
>
> ------------------------------
>
> WARNING: This message is intended only for the named recipients. This
> message may contain information that is confidential. Any dissemination,
> copying, or use of this message or its contents by anyone other than the
> named recipient is strictly prohibited. If you are not a named recipient or
> an employee or agent responsible for delivering this message to a named
> recipient, please notify the sender immediately, and immediately destroy
> this message and any copies you may have. WARNING: Email may not be secure
> unless properly encrypted. It is possible for e-mails to be intercepted or
> affected by viruses. While we maintain virus checks on all e-mails, we
> accept no liability for viruses or other material introduced with this
> message.
> _______________________________________________
> Net-snmp-users mailing list
> [email protected]
> Please see the following page to unsubscribe or change other options:
> https://lists.sourceforge.net/lists/listinfo/net-snmp-users
>

_______________________________________________
Net-snmp-users mailing list
[email protected]
Please see the following page to unsubscribe or change other options:
https://lists.sourceforge.net/lists/listinfo/net-snmp-users