Re: Support for SNMP source trap address
Bill Fenner <[email protected]>
| Newsgroups | gmane.network.net-snmp.user |
|---|---|
| Message-ID | <CAF4SogYK-HD8Hy5DzLCi=U3XKbgvd4nJ8s2o=S4n4dGnBiQ5tQ@mail.gmail.com> |
Yes, the clientaddr is used if a given entry does not have an -s option. Bill On Fri, Sep 27, 2019 at 2:40 AM Nitin Samuel <[email protected]> wrote: > Hi Bill, > Would you know if the ' [snmp] clientaddr ' token will continue > to be honored in 5.8, though some trapsess/trap2sink entries could also > have a ' -s <>' option ? > > Thanks, > NitinVS > > On Sun, Sep 8, 2019 at 10:45 PM Nitin Samuel <[email protected]> wrote: > >> Thanks Bill. >> >> So in 5.8, if I have [snmp] clientaddr <> at the top, followed later by >> a few trapsess hosts but one of which has the new '-s <>' option, will >> clientaddr token be honored for this trap host ? >> >> On Sun, Sep 8, 2019 at 4:21 PM Bill Fenner <[email protected]> wrote: >> >>> On Fri, Sep 6, 2019 at 4:56 PM Chinnapareddygari, Chandrasekharreddy < >>> [email protected]> wrote: >>> >>>> I am using net-snmp 5.7.2 in my project..I want to use SNMP trap >>>> source as user configured IP address. >>>> How can I achieve this ? >>>> >>> >>> In 5.7.2 you can use the “clientaddr” configuration in snmpd.conf to set >>> the source of trap messages. In 5.8, each trap configuration (e.g., >>> trapsink, trapsess) can accept a source address argument as “-s foo”. >>> >>> Bill >>> >>>> _______________________________________________ >>> Net-snmp-users mailing list >>> [email protected] >>> Please see the following page to unsubscribe or change other options: >>> https://lists.sourceforge.net/lists/listinfo/net-snmp-users >>> >> _______________________________________________ Net-snmp-users mailing list [email protected] Please see the following page to unsubscribe or change other options: https://lists.sourceforge.net/lists/listinfo/net-snmp-users