Re: PING question

Well-known problem - run Nagios instead of Netsaint.



On Mon, 18 Nov 2002, Bonk, Noel wrote:

> Hello,
>  
> I just installed and configured Netsaint v0.0.7 on Red Hat 7.3 and note that
> it reported all my hosts as down - when I know they are up and reachable.
> Following what was listed in the FAQ's - I did a check_ping from the command
> prompt and received an error message stating: Could not interpret output
> from ping command. See below:
>  
> libexec]# ./check_ping -H 10.84.100.1 -w 100,60% -c 500,100% -p 5
> <response>
> /bin/ping -n -c 5 10.84.100.1
> Error: Could not interpret output from ping command
>  
> Has anyone run across this before? I have tried changing the values in the
> "check_ping" command multiple times and have still received the same
> response.
>  
> Thanks,
> Noel
>  
> 

-- 




-------------------------------------------------------
This sf.net email is sponsored by: To learn the basics of securing 
your web site with SSL, click here to get a FREE TRIAL of a Thawte 
Server Certificate: http://www.gothawte.com/rd524.html