RE: Editing CGI's

"Martin Mielke (THALES)" <[email protected]> Tue, 17 Dec 2002 14:07:22 +0100

Newsgroups	gmane.network.netsaint.user
Message-ID	<[email protected]>

Hi,

this might seem a dumb answer but you could try vi, emacs or the like...
unless those CGIs are binary files :-P


Martin
  -----Original Message-----
  From: [email protected]
[mailto:[email protected]]On Behalf Of
[email protected]
  Sent: Monday, December 16, 2002 10:35 PM
  To: [email protected]
  Subject: [netsaint] Editing CGI's



  Has anyone edited any of the cgi's in Netsaint? If so, what editor did you
use. I have not had much luck editing the cgi's.

  Thanks,

  Mike Hall
  [email protected]

InterScan_Disclaimer.txt (text/plain, 236 B)

****** Message from InterScan E-Mail VirusWall NT ******

** No virus found in attached file noname.htm

Este correo ha sido procesado por los sistemas de Seguridad de FDI-H24
*****************     End of message     ***************

InterScan_Disclaimer.txt (text/plain, 294 B)

****** Message from InterScan E-Mail VirusWall NT ******

** No virus found in attached file noname.htm
** No virus found in attached file InterScan_Disclaimer.txt

Este correo ha sido procesado por los sistemas de Seguridad de FDI-H24
*****************     End of message     ***************