Re: [NoCatNet] Question

Is your nocat.conf configured correctly?

SDE

* On 30-Jun-2005 at  1:00PM PDT, Billy Dodson said:
> I now have a box with 2 nics.  Everything is installed and appears to be
> working.  When I set a client to point to NoCat for gateway, it never
> captures or presents the splash page.  Do I have to configure ip
> forwarding or anything on the host so that it will route the data on?  I
> can ping the inside IP address of the NoCat box, but I cant ping through
> it.  The NoCat box can ping the networks on both interfaces. 
> 
> 
> Billy Dodson
> Network Engineer
> PMM
> (432) 561-7239
> [email protected]
> www.pmm-i.com
> 
> -----Original Message-----
> From: Schuyler Erle [mailto:[email protected]] 
> Sent: Thursday, June 30, 2005 11:39 AM
> To: Billy Dodson
> Cc: Ken Connell; [email protected]
> Subject: Re: [NoCatNet] Question
> 
> * On 30-Jun-2005 at  8:27AM PDT, Billy Dodson said:
> > Here is the issue.  The NoCat box is going to have 2 private
> addresses.
> > This box sits behind a firewall and another router.  This is not the 
> > last gateway to the internet.  So I don't want this device doing NAT.
> 
> > I have configured the conf for no nat, but the device only has one 
> > ethernet at the current time.  I will try and get another ethernet and
> > try again.   
> 
> You could try setting "RouteOnly" to 1, and have your single ethernet
> interface aliased to two IP addresses on different networks. That
> *might* work, but not having tried it, I can't guarantee for sure...
> 
> SDE
>