Re: No splash page

Thanks!  I'm brand new to this open portal stuff and
didn't know about dd-wrt.  I installed it and it
worked like a charm!

--- Ken Sikora <[email protected]> wrote:

>  I use dd-wrt and it's built in and works.
> 
>   ----- Original Message ----- 
>   From: Joe Peifer 
>   To: [email protected] 
>   Sent: Friday, May 25, 2007 1:28 PM
>   Subject: [NoCat] No splash page
> 
> 
>   No Splash Screen... splashd process halting...
> 
>   This is my first time trying to implement
> NoCatSplash
>   on a Linksys router running OpenWRT. 
> Unfortunately
>   I'm running into a problem I don't understand...
> and
>   am hoping someone out there can provide some
> insight.
> 
>   The device being configured is a Linksys WRT54GSv2
> 
> 
>   PREFACE... 
>   (Feel free to skip to PROBLEM if this is boring)
> 
>   I installed OpenWRT via the Linksys administration
> web
>   interface (version openwrt-wrt54gs-squashfs.bin
> dated
>   03-Feb-2007 as downloaded from
>  
>
http://downloads.openwrt.org/whiterussian/newest/default/)
> 
>   After rebooting the router I pointed my browser at
>   192.168.1.1 and saw the friendly OpenWRT Admin
> Console
> 
>   I set my password and then SSH'd into the device
> as
>   root
> 
>   The following commands appeared to run
> successfully
>   from the SSH terminal...
>   # ipkg update
>   # ipkg install glib1 iptables kmod-iptables-extra
>   # wget
>  
>
http://nocat.net/~sderle/nocatsplash_0.93pre2-2_mipsel.ipk
>   # ipkg install nocatsplash_0.93pre2-2_mipsel.ipk
> 
>   Finally I cold booted the router
> 
>   PROBLEM...
>   I expected at this point that any attempt to
> browse
>   the Internet would result in being redirected
> first to
>   a splash screen.  Instead, the system directed me
>   immediately to the site I was attempting to
> browse.
> 
>   # ps aux
> 
>   returned
> 
>   PID  Uid     VmSize Stat Command
>   1 root        356 S   init       
>       2 root            SW  [keventd]
>       3 root            RWN [ksoftirqd_CPU0]
>       4 root            SW  [kswapd]
>       5 root            SW  [bdflush]
>       6 root            SW  [kupdated]
>       8 root            SW  [mtdblockd]
>      71 root            SWN [jffs2_gcd_mtd4]
>      95 root        344 S   logger -s -p 6 -t  
>      97 root        356 S   init       
>      98 root        348 S   syslogd -C 16 
>     100 root        300 S   klogd 
>     453 root        320 S   wifi up 
>     484 root        392 S   /usr/sbin/dropbear 
>     491 root        368 S   httpd -p 80 -h /www -r
>   OpenWrt 
>     497 root        380 S   udhcpc -i vlan1 -b -p
>   /var/run/vlan1.pid -t 0 -R 
>     500 root        264 S   telnetd -l /bin/login 
>     504 root        336 S   crond -c /etc/crontabs 
>     524 nobody      424 S   dnsmasq -K -F
>   192.168.1.100,192.168.1.249,255.255.255
>     528 root        392 S   /usr/sbin/splashd -D 
>     600 root        596 S   /usr/sbin/dropbear 
>     603 root        440 S   -ash 
>     608 root        344 R   ps aux 
> 
>   Oddly, any attempt to call the NoCatSplash
>   splash-screen directly
>   (http://192.168.1.1:5280/splash.html) causes the
>   splashd process to halt completely (disappears
> from
>   the list of running processes).  I must then
> reboot
>   the router to get the process started again.
> 
>   Any help out there?
> 
> 
>          
>  
>
____________________________________________________________________________________Be
> a better Globetrotter. Get better travel answers
> from someone who knows. Yahoo! Answers - Check it
> out.
>  
>
http://answers.yahoo.com/dir/?link=list&sid=396545469
> 
> 
>   _______________________________________________
>   NoCat mailing list
>   [email protected]
>   http://lists.nocat.net/mailman/listinfo/nocat
> 
>   !DSPAM:46571c1a289521527717022!
> 
> 



       
____________________________________________________________________________________Luggage? GPS? Comic books? 
Check out fitting gifts for grads at Yahoo! Search
http://search.yahoo.com/search?fr=oni_on_mail&p=graduation+gifts&cs=bz