Re: [c-nsp] VPLS to multiple end points

Hey Shawn,

By definition all VPLS circuits are multipoint, VPWS (aka VLL's, xconnects)
is used for point-to-point designations.

Nuance aside, multipoint is a pretty common deployment strategy for L2VPN
services-- you'll want to look at using L2 VFIs for this.

A good reference point would be here:
https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/mp_l2_vpns/configuration/xe-3s/mp-l2-vpns-xe-3s-book/mp-l2vpn-pseudo-swit-xe.html

Additionally, you can look at using BDI's if you need to provide routing
capabilities to the VPLS.

- Michael


On Thu, May 27, 2021 at 6:30 AM Shawn L <[email protected]> wrote:

> Does anyone have any examples of doing a VPLS to multiple end points?
>
> I have a use case where I want to bring in a couple of vlans to an ASR920
> and then transport them via MPLS to several other ASR920s.  So, basically a
> layer-2 vpn.
> Normally, I'd just bring in the vlans, and then do an xconnect on the
> interface over to the destination.  But, I'm struggling with how to send it
> to multiple destinations.
>
> Or, is there a specific reason to _not_ do this and do it some other way?
>
> thanks
>
> Shawn
> _______________________________________________
> cisco-nsp mailing list  [email protected]
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
>
_______________________________________________
cisco-nsp mailing list  [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/