Re: [c-nsp] 7600 (RSP720) good for 1000 x DHCP server config?
Lukasz Bromirski <[email protected]>
| Newsgroups | gmane.network.nsp.cisco |
|---|---|
| Message-ID | <[email protected]> |
Just make sure to apply sane/tested CoPP profile, as DHCP is CPU-bound feature. -- ./ > On 5 Jul 2021, at 13:20, chiel <[email protected]> wrote: > > Hi, > > I might going to use a 7600 with RSP720 to terminate 1000 users, where > each user has a own vlan and L3. I will also be making a 1000 DHCP > config, one for each vlan. > > My question is will the RSP720 have no problem with a 1000 x a DHCP > config? Because the DHCP will be handled by the CPU I guess? I guess > this wont be an issue but just want to check. > > Other then a couple of static routes and fiber termination the 7600 will > not be doing anything else. > > Chiel > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/