Re: [c-nsp] policer on ASR1001X

Hi James,

> On 7 Sep 2021, at 14:10, james list <[email protected]> wrote:
> 
> Dear experts,
> I'd like to rate limit some ingress traffic coming from untrusted source to
> 10Mbs.
> 
> I've an ASR1001X (16.3.7) and this is the config I'd place:
> 
> *********************
> ip access-list extended ACL_10_203_231_129
> permit ip any host 10.203.231.129
> 
> class-map match-all CM_LIMIT_INGRESS
> match access-group name ACL_10_203_231_129
> 
> policy-map PM_LIMIT_INGRESS
> class CM_LIMIT_INGRESS
>  police 10000000 5000000 5000000 conform-action transmit  exceed-action
> drop  violate-action drop
> class class-default
> 
> The PM is attached to tunnel interface:
> 
> TUNNEL0
> service-policy input PM_LIMIT_INGRESS
> 
> *********************
> 
> Can you please confirm:
> 
> 1) I'll not drop/limit other traffic

It won’t. It will apply the policy only to matching traffic (ACL ACL_10_203_231_129).

> 2) ASR1001X applies rate limit in hardware and not in software (in order to
> avoid CPU overload)

Hardware.

> 3) is there any mode to limit pps and not only bandwidth

I no longer remember this from top of my mind, but there’s bunch of good QoS/HQoS presentations about ASR 1000 in particular on ciscolive.com that you can use as reference.

-- 
./
_______________________________________________
cisco-nsp mailing list  [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/