[c-nsp] Vague Recollection of command on modular catalyst switches
Drew Weaver via cisco-nsp <[email protected]>
| Newsgroups | gmane.network.nsp.cisco |
|---|---|
| Message-ID | <[email protected]> |
Hello, The default when you replace a line card in a modular catalyst switch is that it removes the configuration for that line card. I have a vague recollection of there being a command that you could enter to tell it not to do this. Does anyone remember what that command is? It isn't a huge deal to copy/paste the config and then add 'no shutdown' on every port but if you can avoid having to do that.... Thanks, -Drew _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/