[c-nsp] Newbie assistance about filtering netflow export (ascii clean)
Hank Nussbacher via cisco-nsp <[email protected]>
| Newsgroups | gmane.network.nsp.cisco |
|---|---|
| Message-ID | <[email protected]> |
[something screwy happened to my plaintext. Hopefully this is better] I hope someone here has done this. On IOS-XR I want the ability to filter certain IP ranges when doing a Netflow export. I have looked here: https://www.cisco.com/c/en/us/td/docs/routers/asr9000/software/asr9k-r6-5/netflow/configuration/guide/b-netflow-cg-asr9k-65x/b-netflow-cg-asr9k-65x_chapter_010.html#concept_B74CBEBA76D8461C9044B586AA873791 and see there is this: ipv4 access-list nf_ex 10 permit ipv4 192.168.1.1/24 any capture Is this the ACL that indicates which prefixes to export via Netflow and all others are dropped? This applies to both src and dst for this IP range listed? All other IP ranges are dropped? flow monitor-map fmm1 record ipv4 option filtered Is "option filtered" the trick that is needed? Where can I read more about this option? interface 10GE0/0/0/1 ipv4 access-group nf_ex_ing Where in the page was defined nf_ex_ing? I thought it was nf_ex. The only Cisco doc I found that discusses "option filtered" is: https://www.cisco.com/c/en/us/td/docs/routers/asr9000/software/asr9k-r6-5/netflow/configuration/guide/b-netflow-cg-asr9k-65x/b-netflow-cg-asr9k-65x_chapter_010.html Any clue appreciated. Thanks, Hank _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/