Re: [c-nsp] Acceptable port configurations for ASR 9902 (gripe)

On 26/01/2024 15:49, Drew Weaver via cisco-nsp wrote:
> Hello,
> 
> I just have a general gripe that I want to share regarding the ASR9902 and since there is nobody to talk to at Cisco about any of this anymore, I figured I would just share it here.
> 
> This is an acceptable configuration:
> 
> 1x100GE, 1x100GE, 4x25GE, 10x10GE
> 
> But this is not:
> 
> 1x100GE, 1x100GE, 1x100GE,10x10GE
> 
> Think about that for a moment.

Same story for any dual rate card:
https://www.cisco.com/c/en/us/td/docs/iosxr/asr9000/hardware-install/ethernet-line-card-installation-guide/b-asr9k-ethernt-line-card-install-guide/b-asr9k-ethernt-line-card-install-guide_chapter_010.html#id_45620

:-(

-Hank

> 
> Thanks,
> -Drew
> 
> 
> 
> _______________________________________________
> cisco-nsp mailing list  [email protected]
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/

_______________________________________________
cisco-nsp mailing list  [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/