[c-nsp] Local switching on EVPN port

Mihai via cisco-nsp <[email protected]> Fri, 2 Feb 2024 13:05:12 +0000

Newsgroups	gmane.network.nsp.cisco
Message-ID	<[email protected]>

Hi,

On Cisco NCS I can configure local switching between two 
subinterfaces/vlans by adding them to a bridge domain as below:

l2vpn bridge group X bridge-domain X interface Bundle-Ether1.10
l2vpn bridge group X bridge-domain X interface Bundle-Ether1.20

Once I enable EVPN on the physical interface/bundle the local switching 
no longer works.
I kinda understand why it wouldn't work with EVPN but is there some knob 
that I can enable in order to preserve the functionality?

Thanks!
_______________________________________________
cisco-nsp mailing list  [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/