[c-nsp] Recommendation for Cisco router with Full BGP Route
Brandon Butterworth via cisco-nsp <[email protected]> Wed, 05 Mar 2025 16:31:48 +0000
| Newsgroups | gmane.network.nsp.cisco |
|---|---|
| Message-ID | <[email protected]> |
On 05/03/2025 14:07:16, "Pengembara T. via cisco-nsp" <[email protected]> wrote: >Interested at 7280cr2k. But based on thi, its no longer listed R (1st gen) and R2 (2nd gen) are end of sale and heading to end of support, I've not checked every model of R2 but will be similar timetable. https://www.arista.com/en/support/advisories-notices/end-of-sale/15849-end-of-sale-of-the-arista-dcs-7280cr2k-30-series others are here - https://www.arista.com/en/support/advisories-notices/endofsale >Looks like its already replaced with something else. R3 are the current generation if you are buying new, and need support. R and R2 are appearing cheaply used now they hare dropping off support. >Im still did not understand arista model naming convention. > >What about 7280SR3-40YC6 ? Is the control plane able to handle 7280 is the big buffer full table range = router S,Q,C is the general port speed range, I don't know the official nomenclature but it's along the lines of S = slow, they probably mean SFP, Q = QSFP = 40G, C = century = 100G, and so on. R(null,2,3) is generation. K = bigger TCAM -40YC6 = describes port combination -F and M on the end is air flow and ram options As others have mentioned, lots of details in https://www.arista.com/assets/data/pdf/Whitepapers/7280R3-Platform-Architecture-WP.pdf >7280sr3 did not mention bgp table, but mention these: >Cloud Networking Ready > Up to 384K MAC Addresses > Over 2M IPv4 Unicast Routes > Over 5M IPv4 Routes with 7280R3K Those routes are hardware defined, the Flexroute software option is FIB compression and is quite effective (R = 1M TCAM, total fail for a full table, with Flexroute it functions well at about 40% utilisation). It works with K and non K versions but obviously K is a better starting point for very large. BGP table is just ram and there are more ram versions. The same R was tight with the standard 8GB but with 32GB is fine (you can DIY upgrade, 16G is easy, above that for R range the SOC needs unbuffered and 16GB unbuffered is hard to find). brandon _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/