[f-nsp] potential issue with BR-MLX-10Gx20 20-port 1/10GbE Module
Tudor Capatina via foundry-nsp <[email protected]>
| Newsgroups | gmane.network.nsp.foundry |
|---|---|
| Message-ID | <[email protected]> |
Hello, I have an issue with the above mentioned card in a Brocade MLXe . When inserted it comes with a default config of gig-default neg-off under all interfaces, configuration which cannot be removed: (config-if-e10000-1/1)#no gig-default neg-off Error: This command is not supported on this port This generates the issue that if i use a 1G sfp towards some other device and negotiation is not turned off on that end i will not get link. Is there a solution to this? Also for some reason, when using a 10G sfp and connecting to another MLX on a NI-MLX-10Gx4 4-port 10GbE module i do not get link.Is there any plausible explanation? Thanks, Tudor _______________________________________________ foundry-nsp mailing list [email protected] http://puck.nether.net/mailman/listinfo/foundry-nsp