Re: [f-nsp] Brocade XMR / Juniper iBGP Interoperability

Do you have -X model 10Gbps cards?

BR-MLX-10Gx4-X 4-port 10GbE Module

What about management modules? Do you have other full-route BGP sessions on
that 10Gbps card, and just the Juniper ones are having issues? With a -X
module as listed above, and ipv4-ipv6-2 CAM partition, you should see
something like this:

SSH@router#show cam-partition slot 2

CAM partitioning profile: ipv4-ipv6-2

Slot 2 XPP20SP 0:
# of CAM device                = 4
Total CAM Size                 = 917504 entries (63Mbits)

IP: Raw Size 786432, User Size 786432(0 reserved)


Does it show that?


-James


On Wed, Nov 16, 2016 at 11:10 AM, Daniel Stephens <[email protected]> wrote:

> Hi everyone,
>
>
>
> I am having a strange issue with our Brocade XMRs when I attempt to
> exchange routes between a new set of Juniper MX iBGP peers and was looking
> to see if anyone had any recommendations.
>
>
>
> The Brocade XMRs have two line cards, a 20-port 1G and a 4-port 10G card
> installed, and are running 5.6.0d firmware.
>
>
>
> We are integrating two existing networks as a consolidation, with the one
> network running Brocade XMR and the other running Juniper MX routers. The
> issue surfaced on the XMRs when we removed route filters on the iBGP
> sessions between the XMR and MX routers. When lifting the filters and
> sending routes from the XMR towards the MX, everything is functioning as
> normal and the MX correctly learn the routes. Our issue becomes when we
> lift the filter and send routes from the MX towards the XMR. The XMR begins
> to load the routes correctly, and at some point during this process, the
> XMR stops forwarding traffic on the 4-port 10G line card entirely (the card
> to which the MX routers interconnect), and all BGP sessions associated with
> that line card flap, and OSPF adjacencies drop and re-establish.
>
>
>
> I am using the ipv4-ipv6-2 CAM partition profile on the XMR devices. Total
> number of routes attempting to be passed is a full table of roughly 610K
> routes.
>
>
>
> Even when I remove an XMR unit from service and attempt to load routes
> from the MX into the XMR, the same anomaly occurs.
>
>
>
> Any assistance would be greatly appreciated.
>
>
>
> Thanks,
>
> Daniel
>
> _______________________________________________
> foundry-nsp mailing list
> [email protected]
> http://puck.nether.net/mailman/listinfo/foundry-nsp
>



-- 

*James Cornman*


*Chief Technology Officer*[email protected]
212.792.9950 - ext 101

*Atlantic Metro Communications*

*4 Century Drive, Parsippany NJ  07054*


*Colocation • Cloud Hosting • Network Connectivity • Managed Services*
Follow us on Twitter: @atlanticmetro <https://twitter.com/atlanticmetro> *•
Like us on Facebook <https://www.facebook.com/atlanticmetro>*
www.atlanticmetro.net

_______________________________________________
foundry-nsp mailing list
[email protected]
http://puck.nether.net/mailman/listinfo/foundry-nsp