Re: [f-nsp] NetIron 5.8f feedbacks
"i3D.net - Martijn Schmidt" <[email protected]>
| Newsgroups | gmane.network.nsp.foundry |
|---|---|
| Message-ID | <[email protected]> |
Hi Jörg, That SKU is a Gen1 module so it's no longer supported as of 5700 and onwards. BR-MLX-10Gx4-X is a Gen1.1 module and should still work in 5800, but I haven't tested it since it'd block the MLXe chassis from running its switching fabrics in turbo mode - which in turn is needed to achieve wirespeed throughput rates on some of the newer high density linecards. Please note you'll also need MR2 management modules to run >5700 firmware. Best regards, Martijn Schmidt On 19 December 2016 13:04:22 CET, "Jörg Kost" <[email protected]> wrote: >Hi, > >does >NI-XMR-10Gx4 >still boot and run under 5.8? > >Jörg > >On 16 Dec 2016, at 20:14, Youssef Bengelloun-Zahr wrote: > >> @David : No new CAM profiles. I too need to resize in order to >> accomodate IPv6 DFZ growth. >> >> @Martijn : yep, the nasty IPSec bug was corrected, with a couple >> others we were impacted by. Need to lab it a bit, but I think it's >the >> one. >> >> BR. >> >> > >_______________________________________________ >foundry-nsp mailing list >[email protected] >http://puck.nether.net/mailman/listinfo/foundry-nsp -- Sent from my Android device with K-9 Mail. Please excuse my brevity. _______________________________________________ foundry-nsp mailing list [email protected] http://puck.nether.net/mailman/listinfo/foundry-nsp