[f-nsp] Renumbering unit in a FCX stack

All,

I think the answer to this should be easy, but I'm unable to figure it 
out!

I have a unit that was taken out of an extant FCX stack.  It happens to be 
unit 2.  I now want it to be unit 1.

I've been through pages like 
http://www.brocade.com/content/html/en/configuration-guide/fastiron-08030b-switchstackingguidehttp://www.brocade.com/content/html/en/configuration-guide/fastiron-08030b-switchstackingguide 
and tried lots of variants of stack unconfigure me, stack disable, no 
stack enable, but try as I might I cannot get this unit to revert to being 
unit 1.  The recommendation of running "stack secure-setup" doesn't do 
anything useful:

SSH@#stack secure-setup
SSH@#Discovering the stack topology...


Selected Topology:

Active  Id      Type          Mac Address
        2    FCX648S        0024.38c0.bf80


No other units were discovered...

!
ver 08.0.10mT7f1
!
stack unit 2
  module 1 fcx-48-port-management-module
  module 2 fcx-cx4-2-port-16g-module
  module 3 fcx-xfp-2-port-10g-module
  priority 128
  stack-port 2/2/1 2/2/2
stack enable
stack mac 0024.38bf.fb00
...

Anyone any ideas?

    UNIT 2: compiled on Jul 08 2015 at 16:18:42 labeled as FCXS08010m

Jethro.

.  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .
Jethro R Binks, Network Manager,
Information Services Directorate, University Of Strathclyde, Glasgow, UK

The University of Strathclyde is a charitable body, registered in
Scotland, number SC015263.
_______________________________________________
foundry-nsp mailing list
[email protected]
http://puck.nether.net/mailman/listinfo/foundry-nsp