Re: [f-nsp] CER: IPv6 Route ADD: CAM entry creation FAILED

Did you check the CAM utilization?  It's probably full, perhaps you can
partition it differently.

On Wed, Sep 6, 2017 at 2:30 PM, Brian Rak <[email protected]> wrote:

> Has anyone else seem problems with the CER's being unable to add routes
> before?  We have multiple devices (all 2024C-4X) reporting one or both of
> these messages:
>
> IPv6 Route ADD: CAM entry creation FAILED
> IPv4 Network Route ADD: CAM entry creation FAILED
>
> They're learning a full v4+v6 table, but we are well below the limits
> defined in `sh default values`.  From past experience, a reload seems to be
> the only thing that will actually correct this, but that is a pretty
> annoying thing to have to do.
>
> Any ideas for what may be causing this?  We're on 5.6.0m right now.
>
> _______________________________________________
> foundry-nsp mailing list
> [email protected]
> http://puck.nether.net/mailman/listinfo/foundry-nsp




-- 
Be Well,

Derek Labian

_______________________________________________
foundry-nsp mailing list
[email protected]
http://puck.nether.net/mailman/listinfo/foundry-nsp