Re: [f-nsp] OSPF and BGP flapping when enabling a certain amount of BGP neighbors

Chris Wopat <[email protected]> Fri, 29 Jun 2018 07:24:26 -0500

Newsgroups	gmane.network.nsp.foundry
Message-ID	<CALsLHchAQa=p0shoCZBnyXXpj2Sxb4rhx+AARdE=BXWWKi7QKw@mail.gmail.com>

Based on this thread, I went to check if we had that enabled on a few
CER2024F's we have. it's not available at a global level.

SSH@cer2024#show version | inc IronWare
IronWare : Version 5.7.0bT183 Copyright (c) 1996-2014 Brocade
Communications Systems, Inc.


SSH@cer2024f(config)#no ip icmp ?
  burst-normal       Number of packets per second in normal burst mode
  echo               Global ICMP Echo message control
  max-err-msg-rate   ICMP max error message rate per second
  mpls-response      Global ICMP error response control on MPLS labeled
packet
  unreachable        Global ICMP Unreachable message control


Yep we're aware it's old- they're not doing much and haven't been
problematic. Curious what version folks are running? I reached out to
Extreme in February, and they recommended 6.0.00f even though it was not
yet out at the time.

_______________________________________________
foundry-nsp mailing list
[email protected]
http://puck.nether.net/mailman/listinfo/foundry-nsp