Re: [j-nsp] MX304 - Edge Router
Richard McGovern via juniper-nsp <[email protected]>
| Newsgroups | gmane.network.nsp.juniper |
|---|---|
| Message-ID | <BN7PR05MB58919CEDDB9BCC36D2B73EA6AFDDA@BN7PR05MB5891.namprd05.prod.outlook.com> |
#1, sorry I opened up the Women in STEM discussion, was not meant to 😂 The comment about licenses – agree 100% with what was stated. “I'd suggest staying very close to our SE's for the desired outcome we want for this development. As we have seen before, Juniper appear reasonably open to operator feedback, but we would need to give it to them to begin with.” Could not agree more with the above!!! Regards, Rich Richard McGovern Sr Sales Engineer, Juniper Networks 978-618-3342 I’d rather be lucky than good, as I know I am not good I don’t make the news, I just report it Juniper Business Use Only On 10/26/23, 9:40 AM, "Mark Tinka" <[email protected]> wrote: So my SE came back to me a short while ago to say that at present, routing protocols will not be disabled if an MX304 (or some future box/code designed for the same authorization framework) does not have the appropriate license installed. He did add, however, that Juniper are considering enforcing routing protocol licenses in the future, and that he cannot say, with any certainty, that this will not become a thing in the future. I'd suggest staying very close to our SE's for the desired outcome we want for this development. As we have seen before, Juniper appear reasonably open to operator feedback, but we would need to give it to them to begin with. Mark. _______________________________________________ juniper-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/juniper-nsp