Re: [j-nsp] DHCPv6 BLQ (Bulk Lease Query)

--===============8182318549423498308==
Content-Language: en-US
Content-Type: text/plain; charset=UTF-8; format=flowed
Content-Transfer-Encoding: 8bit

Ok wow... it's interesting what you might see when you stare at a screen 
and observe over time... so, I am in fact seeing BLQ work following a 
reboot, but, look how long it takes.  ~9.5 minutes following reboot 
command.  This is absolutely reproducible and happens every time the 
ACX5048 reboots, I did it about 5 times. I'd like to see this happen 
immediately following network convergence, ... like right around the 
time interfaces come up and routing protocol(s) converge... ospf full 
state, bgp established, etc.

Times hacks for what I observed...

00:00 - reboot
02:00 - acx5048 console login prompt
04:10 - ospf full, pinging loopback
09:38 - dhcpv6 blq tcp session seen (and wiresharked)


root@5048> show system connections inet6
fpc0:
--------------------------------------------------------------------------
Active Internet connections (including servers)
Proto Recv-Q Send-Q  Local Address  Foreign Address                      
          (state)
tcp6       0      0  1234:1234:1234::408f.64277 
2468:2468:2468:a0ca:192:168:111:111.547       TIME_WAIT
tcp46      0      0  *.179  *.*                                          
  LISTEN
tcp46      0      0  *.646  *.*                                          
  LISTEN
tcp6       0      0  *.547  *.*                                          
  LISTEN
tcp6       0      0  *.6666 *.*                                          
  LISTEN
tcp6       0      0  *.22 *.*                                          
  LISTEN
udp46      0      0  *.514  *.*
udp46      0      0  *.3503 *.*
udp46      0      0  *.646  *.*
udp46      0      0  *.62465  *.*
udp46      0      0  *.161  *.*
udp6       0      0  *.547  *.*
udp6       0      0  *.6666 *.*
...



On 2/17/2026 12:16 PM, Aaron1 via juniper-nsp wrote:
> I have DHCPv6 BLQ (Bulk Lease Query) working on a Juniper ACX5048 as relay talking to a remote KEA server, but only using the manual CLI “request” command.  I want/need this to work if/when Juniper router reboots.  Any ideas?
>
>
> Aaron
> _______________________________________________
> juniper-nsp mailing list [email protected]
> https://puck.nether.net/mailman/listinfo/juniper-nsp

-- 
-Aaron


--===============8182318549423498308==
Content-Type: text/plain; charset="utf-8"
MIME-Version: 1.0
Content-Transfer-Encoding: base64
Content-Disposition: inline

X19fX19fX19fX19fX19fX19fX19fX19fX19fX19fX19fX19fX19fX19fX19fX18KanVuaXBlci1u
c3AgbWFpbGluZyBsaXN0IGp1bmlwZXItbnNwQHB1Y2submV0aGVyLm5ldApodHRwczovL3B1Y2su
bmV0aGVyLm5ldC9tYWlsbWFuL2xpc3RpbmZvL2p1bmlwZXItbnNwCg==

--===============8182318549423498308==--