Re: openpegasus password file

OK, finally got some time to face my initial PAM authentication
problems.
Result: mea culpa! just missed some pam dev packages on my unbuntu!
Were are all the dependencies of pegasus listed?
The documentation is awful!

regards
Anton


Am Freitag, den 03.06.2011, 09:04 +0200 schrieb Anton Hergenröder:
> Simple Test:
> - Pegasus compiles and builds Fine without pam auth enabled by environment variable
> - the Same environment and setup but pam enabled and i get the errors
> 
> Maybe i'll have some more time next week to take a closer look on my build logs...
> 
> Best regards
> Anton 
> 
> Am 03.06.2011 um 08:10 schrieb "Deshpande, Rohini (STSD)" <[email protected]>:
> 
> > Can you check your PATH environment variable? Maybe the location of cimmofl is not found. It is found in "bin" directory of your build directory.
> > I'm not sure how the two(PAM & cimmofl) are related, maybe some test setup.
> > 
> > Regards,
> > Rohini
> > 
> > -----Original Message-----
> > From: Anton Hergenröder [mailto:[email protected]] 
> > Sent: Wednesday, June 01, 2011 6:18 PM
> > To: [email protected]
> > Subject: RE: openpegasus password file
> > 
> > OpenPegasus 2.11.00 does not compile with
> > PEGASUS_PAM_AUTHENTICATION=true, saying "cimmofl not found".
> > Something goes wrong while building the tools :(
> > 
> > Am Mittwoch, den 01.06.2011, 09:59 +0000 schrieb Deshpande, Rohini
> > (STSD):
> >> Anton,
> >> 
> >> Open Pegasus uses PAM, so it does use /etc/shadow if present. The PAM conf file Open Pegasus uses is usually named /etc/pam.d/wbem.
> >> 
> >> You can modify the above PAM configuration file to allow non local users. But currently there is a defect related to this http://bugzilla.openpegasus.org/show_bug.cgi?id=8653. You can try the patch in the bug.
> >> 
> >> Regards,
> >> Rohini
> >> 
> >> -----Original Message-----
> >> From: Anton Hergenröder [mailto:[email protected]] 
> >> Sent: Wednesday, June 01, 2011 2:55 PM
> >> To: [email protected]
> >> Subject: openpegasus password file
> >> 
> >> Is there any way to use an existing password file, like shadow on linux
> >> systems? As cimserver requires all its users to be valid local system
> >> users, it is tricky to permit users to change their passwords...
> >> 
> >> Generally, why does pegasus require all its users be valid local users?
> >> As we have a quite dynamic set of pegasus users, it's a big effort to
> >> manage this....
> >> 
> >> Best regards
> >> Anton Hergenröder
> >> 
> >> 
> > 
> > 
> > 
>