RE: cimprovider/cimconfig commands will crash cimserver if configured for non-standard http(s) port
"Sampige, Sahana Prabhakar \(R&D Bangalore\)" <[email protected]>
| Newsgroups | gmane.network.open-pegasus.general |
|---|---|
| Message-ID | <3051CFF4B0ABBF418CBA816A2BF3F203361DDBA983@GVW1105EXC.americas.hpqcorp.net> |
Hi Veeresh, Have you checked if these non-standard ports are not used by any other service running on the windows server ? Pegasus code depends on two configuration parameters to identify the ports for communication and using non-standard port should work just fine. Do you have some trace files or dump files that you can share to analyze further ? -Sahana From: Yaligar, Veeresh S (USD SRDL) Sent: Thursday, September 08, 2011 12:46 PM To: [email protected] Subject: cimprovider/cimconfig commands will crash cimserver if configured for non-standard http(s) port Hi On a windows setup I have cimserver configured to with non-standard port. The service will crash as soon as I execute cimprovider -ls or cimconfig -lc commands. This does not happened if its configured to default ports like 5988 and 5989.. This is observed both in 2.10.0 and 2.11.0 versions. Any clue ? Thanks Veeresh