Re: syncrepl partial copy

FRLinux <[email protected]> writes:

> Hello,
>
> I am now facing a new issue which could well be due to me but I need
> to be sure. I have set a new slave running 2.4.17 on Debian whilst the
> master is a 2.3.43 running on FreeBSD 6.4. I have observed a similar
> behavior on a slave running 2.3.43 also on FreeBSD.
>
> That behavior is that when you start an empty database, syncrepl
> starts copying the content but usually stops after a while (ie. copies
> only part of the database but far from all objects).
>
> Is it recommended to slapcat the objects when setting up a new slave
> or is syncrepl able to do that by itself?
>
> This is my syncrepl rules:
>
> syncrepl rid=124 \
> provider=ldaps://masterldap.example.com:636 \
> type=refreshAndPersist  \
> searchbase="dc=example,dc=com" \
> scope=sub \
> filter="(objectClass=*)" \
> attrs="*" \
> schemachecking=off \
> tls_cacert=/etc/ldap/cert/cacert.pem \
> binddn="cn=ldaprep,dc=example,dc=com" \
> credentials=xxxxxx

Set proper limits on provider and consumer, otherwise the default
limit settings are applicable to cn=ldaprep,dc=example,dc=com.

-Dieter

-- 
Dieter Klünter | Systemberatung
http://dkluenter.de
GPG Key ID:8EF7B6C6
53°37'09,95"N
10°08'02,42"E