Re: Mirror of Master 2.4 and slave 2.3: slave silently exits(0)

В Чтв, 05/11/2009 в 17:53 -0800, Quanah Gibson-Mount пишет:
> --On Thursday, November 05, 2009 12:16 PM +0200 Покотиленко 
> Костик <[email protected]> wrote:
> 
> > I've set up 2 slapd in mirror mode. All worked fine until some moment.
> >
> > Now slave server exists(0) just after start and sync. Master is 2.4,
> > slave is 2.3. During sync there are alot of "bdb_search: ## does not
> > match filter" log entries. What may cause this?
> >
> > Last lines on slave:
> >
> > bdb_search: 92 does not match filter
> > send_ldap_result: conn=-1 op=0 p=0
> 
> 2.3 doesn't support Mirror Mode.  You also cannot replicate from a 2.4 
> master to a 2.3 slave.  You can only replicate from a 2.3.43 master to some 
> of the later 2.4 releases.  Since you don't include any real version 
> information, it's not possible to help you much past this general advice.

Master: Debian Lenny, slapd 2.4.11
Slave: Debian Etch, slapd 2.3.30

So if I've had at least 2.3.43 on Etch, I could just make it master, but
with those versions I have no chances?

Also, Can I have more than 2 servers in mirror? How can it be done if
so?

-- 
Покотиленко Костик <[email protected]>