Re: Bug when converting syncprov-checkpoint to olcSpCheckpoint?

"Kyle Blaney" <[email protected]> writes:

> I am experiencing unexpected results when converting the syncprov-checkpoint
> option in file-based configuration to the olcSpCheckpoint attribute in online
> configuration.
>
> To reproduce the unexpected results:
>
> 1.  Configure OpenLDAP using file-based configuration that contains the
> following line:
>
> syncprov-checkpoint 100 10
>
> 2.  Convert file-based configuration to online configuration using the
> following command:
>
> slapd -f slapd.conf -F slapd.d
>
> My file-based configuration is converted to the cn=config database, but after
> conversion the value of the olcSpCheckpoint attribute in the olcOverlay={1}
> syncprov,olcDatabase={1}bdb,cn=config entry is "100 600" when I expect it to
> be the same as in my file-based configuration ("100 10").
>
> Is this a bug or does the olcSpCheckpoint attribute use different units
> (seconds) than the syncprov-checkpoint option (minutes)?

It seems that the slapo-syncprov(5) defines minutes, but the parser
converts minutes into seconds.
Im am on 2.4.19 and get similar results

,----[ syncprov.ldif ]
| dn: olcOverlay={3}syncprov
| objectClass: olcOverlayConfig
| objectClass: olcSyncProvConfig
| olcOverlay: {3}syncprov
| olcSpCheckpoint: 5 300
| olcSpReloadHint: TRUE
| structuralObjectClass: olcSyncProvConfig
`----

,----[ slapd.conf ]
| overlay syncprov
| syncprov-reloadhint true
| syncprov-checkpoint 5 5
`----

but I wouldn't consider it a bug.

-Dieter

-- 
Dieter Klünter | Systemberatung
http://dkluenter.de
GPG Key ID:8EF7B6C6
53°37'09,95"N
10°08'02,42"E