Re: enhanced linkd problem
"Seibold, Michael" <[email protected]>
| Newsgroups | gmane.network.opennms.general |
|---|---|
| Message-ID | <[email protected]> |
Hi Anuvesh, can you do snmpwalks of the mibs enlinkd uses (they are dokumented in the wiki)? Sometimes the devices deliver wrong informations, sometimes it's a problem within enlinkd. Without the information of the mib walks it's almost impossible to ind out where the problem is. Also please always provide the version of opennms you are running is you have such questions. -Michael Von: Anuvesh Sinha [mailto:[email protected]] Gesendet: Freitag, 1. September 2017 06:35 An: General OpenNMS Discussion <[email protected]> Betreff: [opennms-discuss] enhanced linkd problem Hello, I have connected 2 switches with each other and one switch is connected on LAN. But topology map is very inconsistent sometimes it shows that both switches are connected to LAN and sometimes it gives wrong information ie port 29 which is connected to LAN is shown to be connected to other switch. When i debug this on opennms then i found that in bridge forwarding table present in "node detailed info" of opennms GUI for a particular node is showing those wrong values. Also , In "view node detailed info" of opennms GUI for the discovered node when I see the information under LLDP sometimes it is shown and sometimes it is not shown. Regards, Anuvesh ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Please read the OpenNMS Mailing List FAQ: http://www.opennms.org/index.php/Mailing_List_FAQ opennms-discuss mailing list To *unsubscribe* or change your subscription options, see the bottom of this page: https://lists.sourceforge.net/lists/listinfo/opennms-discuss