SNMPv3 and Datacollection
"Proulx, Mark J" <[email protected]>
| Newsgroups | gmane.network.opennms.general |
|---|---|
| Message-ID | <[email protected]> |
All, I have a question concerning SNMPv3. We are running OpenNMS 16.0.3 and 17.1.1 on various servers to monitor hosts in different locations. We recently updated our Cisco devices to use SNMPv3 authNoPriv from SNMPv2. After the update, there is no historical data to display in the resource graphs. We can SNMP walk the devices with the v3 credentials and the SNMP monitored service for the host is Green in Availability. Other SNMPv2 devices (Linux host) are collecting data properly. NRT-Graphing does not display any data for the selected graph, but the strip chart is incrementing time-wise. Reading about Datacollection, I noticed that it uses v2 bulk requests, is there a setting that I need to adjust for v3? I have Googled and looked in this group for any suggestions, I apologize if I have missed it. Mark J. Proulx Lockheed Martin SSC Email: [email protected]<mailto:[email protected]> ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Please read the OpenNMS Mailing List FAQ: http://www.opennms.org/index.php/Mailing_List_FAQ opennms-discuss mailing list To *unsubscribe* or change your subscription options, see the bottom of this page: https://lists.sourceforge.net/lists/listinfo/opennms-discuss