Collect data from physical switchports

Hi all,

I'm looking for an easy solution for the following requirement:

In our branches we use Cisco Routers with 4 Port switchcards (HWIC/NIM-ES4 etc)

The ports of these cards work as vlan trunk or for specific devices in access mode.

By default, opennms does not collect metrics of these interfaces.

I suggest because they have no ip assigned and so i need to activate datacollection

manually in "Configure SNMP Data Collection per Interface"

For hundreds of routers... uuuh

Is there a way in the config of opennms to activate datacollection on all

physical ports depending on a surveillance category (eg. DataCollect-SWitchports) ?

Thanks in advance

Norbert

------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot

_______________________________________________
Please read the OpenNMS Mailing List FAQ:
http://www.opennms.org/index.php/Mailing_List_FAQ

opennms-discuss mailing list

To *unsubscribe* or change your subscription options, see the bottom of this page:
https://lists.sourceforge.net/lists/listinfo/opennms-discuss