Re: OpenNMS not seeing incoming SNMPv3 traps
"Oleksiy Zhukovsky" <[email protected]> Tue, 12 Jun 2018 15:44:43 +0300
| Newsgroups | gmane.network.opennms.general |
|---|---|
| Message-ID | <[email protected]> |
Hi Jonathan, I am using v22.0.0.1. However, I can successfully receive SNMPv3 traps I am sending from the same machine to OpenNMS. Just in case there is an issue with v22, is it possible to do a downgrade, or force installation of a specific OpenNMS version? Best regards, Oleksiy Zhukovsky From: Jonathan Heard <[email protected]> Sent: Monday, June 11, 2018 1:09 PM To: [email protected] Subject: Re: [opennms-discuss] OpenNMS not seeing incoming SNMPv3 traps Hi Oleksiy, Since upgrading OpenNMS a while back, I recently discovered that SNMPv3 traps we no longer getting through... I think it was version 21.2 and we've just upgraded to 22.0 so it's on my to-do list to recheck SNMPv3 traps and see if it's working again. What version are you using? Thanks Jonathan On 09/06/18 19:20, Oleksiy Zhukovsky wrote: Hi All! I am setting up OpenNMS to listen to a stream of SNMP traps from an external EMS and ran into an issue. The OpenNMS instance has been configured to receive SNMP v3 traps and I can successfully receive traps I am sending from the server where OpenNMS is installed, however OpenNMS doesn't see any traps coming from outside. At first it seemed like a firewall issue, but I can see the incoming traps via Wireshark on the same machine, so the packets are not dropped. I've enabled debug-level logging for trapd and the log doesn't show any activity when I see a new trap from EMS appear in Wireshark. Either I am missing some piece of configuration, or there is a deeper firewall-related issue at work here. Just case, here is the iptables configuration I have at the moment. Please let me know what other relevant pieces of configuration can help with troubleshooting. Chain INPUT (policy ACCEPT 891K packets, 285M bytes) pkts bytes target prot opt in out source destination 0 0 ACCEPT udp -- enp0s25 * 0.0.0.0 0.0.0.0/0 udp dpts:161:162 0 0 ACCEPT udp -- enp0s25 * 0.0.0.0/0 0.0.0.0/0 udp spts:161:162 dpts:1024:65535 state ESTABLISHED Chain FORWARD (policy ACCEPT 0 packets, 0 bytes) pkts bytes target prot opt in out source destination Chain OUTPUT (policy ACCEPT 949K packets, 341M bytes) pkts bytes target prot opt in out source destination 0 0 ACCEPT udp -- * * 0.0.0.0/0 0.0.0.0 udp dpts:1024:65535 96 14276 ACCEPT udp -- * * 0.0.0.0/0 0.0.0.0/0 udp spts:1024:65535 dpts:161:162 state NEW,ESTABLISHED Thanks in advance for the assistance. Best regards, Oleksiy Zhukovsky <https://www.avast.com/sig-email?utm_medium=email&utm_source=link&utm_campai gn=sig-email&utm_content=emailclient&utm_term=icon> Virus-free. <https://www.avast.com/sig-email?utm_medium=email&utm_source=link&utm_campai gn=sig-email&utm_content=emailclient&utm_term=link> www.avast.com ---------------------------------------------------------------------------- -- Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Please read the OpenNMS Mailing List FAQ: http://www.opennms.org/index.php/Mailing_List_FAQ opennms-discuss mailing list To *unsubscribe* or change your subscription options, see the bottom of this page: https://lists.sourceforge.net/lists/listinfo/opennms-discuss --- This email has been checked for viruses by Avast antivirus software. https://www.avast.com/antivirus ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Please read the OpenNMS Mailing List FAQ: http://www.opennms.org/index.php/Mailing_List_FAQ opennms-discuss mailing list To *unsubscribe* or change your subscription options, see the bottom of this page: https://lists.sourceforge.net/lists/listinfo/opennms-discuss