monitoring VM with 10GB interfaces - "The parameter reached a value of 4294967294 "

Hi,

I started getting notifications about threshold reached
as follows :

'..

A Threshold has been exceeded on node: XXXXX , interface:172.31.255.3.

The parameter reached a value of 4294967294 while the threshold is 1.0.

This alert will be rearmed when it reaches 0.0.

 .."


All my nodes are VMWare virtual machines running on same cluster but these
notifications are coming only form 2 of them

The only difference I can see is that there internal interface is 10GB


Searching the Internet I found a document stating that


".... For interfaces that do not vary in bandwidth or interfaces for which
no accurate estimation can be made, ifSpeed should contain the nominal
bandwidth

For 10G: Value displayed is 4294967295

.."



Is there a different MIB or specific config that needs to be deployed in
order for OpenNMS to better deal with 10GB interfaces ?



Many thanks

Steven

------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot

_______________________________________________
Please read the OpenNMS Mailing List FAQ:
http://www.opennms.org/index.php/Mailing_List_FAQ

opennms-discuss mailing list

To *unsubscribe* or change your subscription options, see the bottom of this page:
https://lists.sourceforge.net/lists/listinfo/opennms-discuss