Re: SNMP V3 trap config?

On 2/9/2012 3:10 PM, Tarus Balog wrote:
> On Thu, 2012-02-09 at 12:27 -0600, Joe Moore in Mpls. wrote:
>> If anybody is doing this, or can point me to docs specific to traps
>> with
>> v3, I'd appreciate a response.
>>
>>
> This help?
>
> http://www.opennms.org/wiki/Trapd#SNMPv3
>
> -T

Thanks Tarus!

I think that will help considerably.

Is there a way to define the "snmp Engine-ID" for OpenNMS in the 
trapd-configuration.xml file? or alternatively, figure out what the 
default or existing Engine-ID is?

I can't create the snmp remote user on the Cisco routers until I define 
the remote Engine-ID of the OPenNMS trap receiver. Cisco docs are vague 
on this so I'm only assuming this parameter needs to match at both ends 
but it may just be an arbitrary unique identifier. I've yet to figure 
that out.

             Thanks again   ...jgm





------------------------------------------------------------------------------
Virtualization & Cloud Management Using Capacity Planning
Cloud computing makes use of virtualization - but cloud computing 
also focuses on allowing computing to be delivered as a service.
http://www.accelacomm.com/jaw/sfnl/114/51521223/
_______________________________________________
Please read the OpenNMS Mailing List FAQ:
http://www.opennms.org/index.php/Mailing_List_FAQ

opennms-install mailing list

To *unsubscribe* or change your subscription options, see the bottom of this page:
https://lists.sourceforge.net/lists/listinfo/opennms-install