[quagga-users 14838] Quagga version 1.1.1 BGP peer-group send-community support ??

Hi,

We are using quagga version 1.1.1as a route-server  and have just noticed
that send-community doesn't appear to work when configured under a
peer-group -


Config snippet as follows -

 neighbor ROUTE-SERVER_POLICY_IPV4_IN peer-group
 neighbor ROUTE-SERVER_POLICY_IPV4_IN ttl-security hops 1
 neighbor ROUTE-SERVER_POLICY_IPV4_IN timers 5 15
 neighbor ROUTE-SERVER_POLICY_IPV4_IN activate
 neighbor ROUTE-SERVER_POLICY_IPV4_IN *send-community both*
 neighbor ROUTE-SERVER_POLICY_IPV4_IN soft-reconfiguration inbound
 neighbor ROUTE-SERVER_POLICY_IPV4_IN maximum-prefix 1 100
 neighbor ROUTE-SERVER_POLICY_IPV4_IN route-server-client
 neighbor ROUTE-SERVER_POLICY_IPV4_IN route-map IPV4_IN in
 neighbor ROUTE-SERVER_POLICY_IPV4_IN route-map IPV4_OUT out

route-map IPV4_OUT deny 10
 match ip address prefix-list IPV4_DENIED_PREFIXES
!
route-map IPV4_OUT deny 20
 match as-path 99
!
route-map IPV4_OUT permit 100
 *set community 12345:2 additive*
 set origin igp

As you cn see we are explicitly setting a community in the outbound
route-map but neighbors are not receiving the community.

Has anyone seen this before or knows that this is working (or not)  or
perhaps can point me to a thread where this has been discussed before?
Can't seem to find a searchable archive of this list :(

Thanks daz

_______________________________________________
Quagga-users mailing list
Quagga-users-UOy77sIEA+cAd7ICUelF/[email protected]
https://lists.quagga.net/mailman/listinfo/quagga-users