[quagga-users 14841] Re: Static route with next hop works when configured in kernel but not when configured via quagga(?)

On 06/10/17 03:14, Alexis Rosen wrote:
> On Oct 4, 2017, at 11:23 PM, Jesse Sanford <[email protected]> wrote:
>> Hello all, My appologies for my lack of experience with the edgerouter brand. I may confuse the names of the software packages being used by the edgerouter for it's routing functionality. I believe that quagga is the software router that the edgrouter pro series uses at least. If not then my apologies for posting to the wrong list.
> 
> Edgerouter software was forked from Vyatta, part of which was forked from Quagga a long time ago. They are quite different now - the configuration CLI is entirely different. You should post this in the Ubiquiti fora unless you think there's something pertaining to the underlying routing code that is common between Ubiquiti Quagga.

EdgeMAX switched to using ZebOS in 1.8 as well, which is the commercial
version of the old open source Zebra, that Quagga forked from. So it's
definitely nothing to with Quagga now. http://community.ubnt.com/ is the
Ubiquiti forum btw.

-- 
James Andrewartha
Network & Projects Engineer
Christ Church Grammar School
Claremont, Western Australia
Ph. (08) 9442 1757
Mob. 0424 160 877