Re: [rancid] Need to Add "Show Version" CMD
Devesh Singh <[email protected]>
| Newsgroups | gmane.network.rancid |
|---|---|
| Message-ID | <CAGSLyinavxrOgpmOO2D7STgVC1RM7RLHZj9TW25rAaT7TdFq9g@mail.gmail.com> |
Hello Heasley,
Thanks for your response!! .
To be more specific i want to see the "Configuration last modified by " in
the backup taken by rancid.
But this is not been captured by show version. I think it is filtering the
output command that rancid take by show version CMD.
Can you please suggest/ advice.
I am using ASA 9.9 version.
On firewall i can see the "Configuration last modified by XXX" when i run
show version, but not in RAncid backup.
Thanks
Dev
On Thu, Aug 30, 2018 at 8:18 PM heasley <[email protected]> wrote:
> Thu, Aug 30, 2018 at 04:54:52PM +0530, Devesh Singh:
> > Hello team,
> > Can you please help/guide me to add "Show Version" CMD in
> rancid
> > for Cisco ASA Firewall, while taking the backup.
>
> show version is collected by default.
>
_______________________________________________
Rancid-discuss mailing list
[email protected]
http://www.shrubbery.net/mailman/listinfo/rancid-discuss