Re: This config was working on 1.8 but now ...

Hi Hamid,

I believe that a problem with user-level ToDevice might have caused this.  The 
problem is fixed in the current version...

Eddie


On 8/4/11 2:31 AM, Hamid Farhadi wrote:
> Dear all,
>
> this config is working on click 1.8, but now on click 2.0 I can not
> receive packet from (tap0 ->):
> this is the summary: eth0 ->  tap0 ->  switch ->  tap1 ->  eth0.
>
>
> AddressInfo(tap0_MAC 10:10:10:10:10:10, tap1_MAC 20:20:20:20:20:20, eth0
> 00:0c:29:35:e0:cb, redirector_eth1 00:0c:29:b7:88:88);
>
> tap0 :: KernelTap(10.0.0.1/8, ETHER tap0_MAC);
> tap1 :: KernelTap(2.0.0.1/8, ETHER tap1_MAC);
>
> tap0_q:: Queue;
> tap1_q:: Queue ->  ToDevice(tap1);
>
> FromDevice(eth0) ->  cl ::  Classifier(14/44,-);
>
> cl[0]
>       ->  Strip(15)
>       ->  EtherEncap(0x0800, eth0 , tap0_MAC )
>       ->  tap0_q
>       ->  ToDevice(tap0);
>
> cl[1] ->  Discard;
>
>     switch :: EtherSwitch(TIMEOUT 0);
>
>     tap0 ->  t :: Tee ->  [0] switch [0] ->  tap1_q;
>     t[1] ->  [1] switch [1] ->  Discard;
>
> tap1  ->   Queue ->  Strip(13)
>           ->  StoreData(0,3)
>           ->  EtherEncap(0x0800, eth0 , redirector_eth1 )
>           ->ToDevice(eth0);
>
>
> am I mistaking somewhere else please?
> Thank you in advance
> hamid
>
>
> _______________________________________________
> click mailing list
> [email protected]
> https://amsterdam.lcs.mit.edu/mailman/listinfo/click