Re: where click module binary image location ?

I mean the the one which contains or follows the click configuration file
created by the user , i.e. after you write your configuration file you
use click-install start click inside the kernel. My understanding is that
the click-install should create a binary image or code which can be
executed by the kernel, the image should be like drivers images ending with
.ko and located somewhere. I don't think /use/local/lib/click.ko is that
image, because it doesn't change when you load a new configuration file
 using click.install


> 2011/11/4 kele kele <[email protected]>
>
>> Do you mean the click.ko and proclikefs.ko? If you install click default,
>> the click imag is in /use/local/lib/click.ko
>>
>> 在 2011年11月3日星期四，ahmed A. <[email protected]> 写道：
>>
>> > Hello everyone,
>> >
>> > Can anyone tell where the Click module binary image is located after it
>> is
>> > loaded to the kernel using Click-install. For example for the netwok
>> driver
>> > e1000
>> > the binary image can be found at
>> > /lib/module/2.6.18/kernel/driver/net/e1000/e1000.ko, so where click
>> loaded
>> > image is located ??????
>> >
>> > I need this image to attach it to oprofile to map the samples measured
>> back
>> > to the code ....
>> >
>> >
>> > I would appreciate any help or tips .
>> >
>> > Bests,
>> > Ahmed
>> > _______________________________________________
>> > click mailing list
>> > [email protected]
>> > https://amsterdam.lcs.mit.edu/mailman/listinfo/click
>> >
>
>
>
_______________________________________________
click mailing list
[email protected]
https://amsterdam.lcs.mit.edu/mailman/listinfo/click