Re: Nsclick and Netflow

Hi Anthony,

Yes, whenever you add source code for a new element, or remove source
code, you need to run "make elemlist" so that the build process finds
the new set of elements.

Not the best aspect of the build process.

Eddie


On Wed, Jan 18, 2012 at 2:00 AM, Anthony Dempsey
<[email protected]> wrote:
> Hi Eddie, the problem I was seeing was that certain elements were
> undefined. I configured with --enable-local but I didn't run make elemlist,
> when I'm adding to Click should I do this?
>
> I've fixed my problem now, in some of the netflow files the Click code
> wasn't surrounded by CLICK_DECLS/END_DECLS once I put these lines in
> everything compiled fine and I could run NS-3 with the code I needed.
> Cheers,
> Anthony.
>
> On Tue, Jan 17, 2012 at 3:52 PM, Eddie Kohler <[email protected]> wrote:
>
>> Anthony, after you move the elements into "local", what problem do you
>> see? And did you configure with "--enable-local", and run "make elemlist"
>> after moving the netflow elements into elements/local?
>>
>> Eddie
>>
>>
>>
>> On 1/17/12 5:41 AM, Anthony Dempsey wrote:
>>
>>> Hi I'm trying to get the netflow package to work with nsclick.
>>> How do I go about trying to get the packages to work together?
>>> I've tried adding ELEMENT_REQUIRES(userlevel|ns) to all the netflow files
>>> and compiling them from the local directory with the commands to enable
>>> nsclick, userlevel, and local wiht linux module disabled but this hasn't
>>> worked.
>>> Any help would be greatly appreciated.
>>> Cheers,
>>> Anthony
>>> ______________________________**_________________
>>> click mailing list
>>> [email protected]
>>> https://amsterdam.lcs.mit.edu/**mailman/listinfo/click<https://amsterdam.lcs.mit.edu/mailman/listinfo/click>
>>>
>>
> _______________________________________________
> click mailing list
> [email protected]
> https://amsterdam.lcs.mit.edu/mailman/listinfo/click