Re: Click Question

Casey,

You will need to set sufficient compile options to create i386 binaries.

Adding "CFLAGS=-m32" to the ./configure line MAY suffice.

Eddie


On Thu, Jun 21, 2012 at 2:48 PM, Casey O'Brien <[email protected]> wrote:
> Hello,
>
> I'm trying to run userlever click on planet-lab. My development machine is
> an amd 64-bit processor. The planet-lab processors are i386. When I run the
> click module on my planet-lab nodes, they give me the error "cannot execute
> binary file." I set up click using:
>
> ./configure --prefix=/home/mit_psirp --disable-linuxmodule
> sudo make install
> cd userlevel
> sudo make install
>
>
> Are there any ideas/ Do I need to add an option into configure in
> order to make it work?
>
>
> Thanks!
>
>
> --
> Casey O'Brien
> Massachusetts Institute of Technology '14
> Course 6-3: Computer Science
> Course 18: Mathematics
> [email protected]
> _______________________________________________
> click mailing list
> [email protected]
> https://amsterdam.lcs.mit.edu/mailman/listinfo/click