Re: slrnpull build / install broken
Adam Williamson <[email protected]>
| Newsgroups | gmane.network.slrn.user |
|---|---|
| Organization | Mandriva |
| Message-ID | <[email protected]> |
On Wed, 2008-02-13 at 00:44 -0500, Rudy Taraschi wrote: > On Feb 12, 2008 6:43 PM, Adam Williamson <[email protected]> wrote: > > Hi, guys. As a new release seems to be imminent, this might be > > important. Unless I'm doing something wrong, the --with-slrnpull > > parameter doesn't seem to work any more in current SVN. Doing a build > > with this parameter doesn't result in slrnpull (and its manpage) being > > built and installed. > > > > Just check out current SVN, do ./configure --with-slrnpull , make , then > > note that there's no slrnpull in src/objs . > > You need to do a "make slrnpull" after the "make". slrnpull seems to > work fine so far. Yes, that was my workaround. But it shouldn't be necessary. It also doesn't fix the slrnpull.1 manpage not being installed, for which I just did a quick hack to the Makefile as that's sufficient for our purposes. This used to work, and it's obviously supposed to. make slrnpull works without any ./configure parameter, so if that was the correct way to do it, there would be no reason for the --with-slrnpull parameter to exist at all. -- adamw > ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/