Re: 4.2 IP Multicast issues

Hi Jonathan,

I patched 4.2.0rc2 and it works perfectly with the IP Multicast domain.

Thanks a lot,
Marcelo

From: Jonathan Stanton [mailto:[email protected]]
Sent: Wednesday, June 06, 2012 5:25 AM
To: Marcelo San-Martin
Cc: [email protected]
Subject: Re: [Spread-users] 4.2 IP Multicast issues

Hello Marcelo,

I've isolated what was going wrong with the multicast joins in this case, it was a change in behavior of the underlying multicast code we use. Please try the attached patch which applies to the 4.2.0rc2 release. It should fix the problem.

I'll also release a new version in the next day.

Thanks,

Jonathan

-------------------------------------------------------------------------------
Jonathan Stanton                [email protected]<mailto:[email protected]>
Spread Group Messaging  www.spread.org<http://www.spread.org>
Spread Concepts LLC      www.spreadconcepts.com<http://www.spreadconcepts.com>
-------------------------------------------------------------------------------



On May 9, 2012, at 7:21 PM, Marcelo San-Martin wrote:

> Hi,
> I was working with Spread 4.1 using multicast addresses with no problems and when I switch to 4.2 it doesn't work anymore.
> I get an alarm and exit with the following error:
>
> [Wed 09 May 2012 16:13:35] DL_init_channel: problem in setsockopt to multicast address 239.10.10.10
> Exit caused by Alarm(EXIT)
>
> I check the code in data_link.c and I do not see much differences with the previous version.
>
> My configuration looks like this:
>
> Spread_Segment 239.10.10.10:4803 {
>        ASD-SC1 10.21.69.51
>        {
>                D 10.21.69.51
>                C 127.0.0.1
>        }
>        ASD-SC2 10.21.69.52
>        {
>                D 10.21.69.52
>                C 127.0.0.1
>        }
>        ASD-SC3 10.21.69.53
>        {
>                D 10.21.69.53
>                C 127.0.0.1
>        }
>        ASD-SC4 10.21.69.54
>        {
>                D 10.21.69.54
>                C 127.0.0.1
>        }
> }
>
> This config file works with 4.1.
>
> Have there been any changes on this area?
>
> Thanks,
> Marcelo
>
> _______________________________________________
> Spread-users mailing list
> [email protected]<mailto:[email protected]>
> http://lists.spread.org/mailman/listinfo/spread-users

_______________________________________________
Spread-users mailing list
[email protected]
http://lists.spread.org/mailman/listinfo/spread-users