Recoverying from a network failure

Hello!

I am simulating a network failure by unplug the switch for a while. If
I have the
network down for some minutes the spread-bus will not recover.

I just get a lot of;

Memb_token_loss: I lost my token, state is 6
[Fri 13 Dec 2013 14:17:39] Scast_alive: State is 2
[Fri 13 Dec 2013 14:17:40] Scast_alive: State is 2
[Fri 13 Dec 2013 14:17:41] Memb_handle_message: handling join message
from 192.168.0.10, State is 2
[Fri 13 Dec 2013 14:17:41] Send_join: State is 4
[Fri 13 Dec 2013 14:17:42] Memb_handle_message: handling join message
from 192.168.0.10, State is 4
[Fri 13 Dec 2013 14:17:42] Send_join: State is 4
[Fri 13 Dec 2013 14:17:43] Memb_handle_message: handling join message
from 192.168.0.10, State is 4
[Fri 13 Dec 2013 14:17:43] Send_join: State is 4
[Fri 13 Dec 2013 14:17:44] Memb_handle_message: handling join message
from 192.168.0.10, State is 4
[Fri 13 Dec 2013 14:17:44] Send_join: State is 4
[Fri 13 Dec 2013 14:17:45] Memb_handle_message: handling join message
from 192.168.0.10, State is 4
[Fri 13 Dec 2013 14:17:45] Send_join: State is 4
[Fri 13 Dec 2013 14:17:46] Memb_handle_token: handling form1 token
[Fri 13 Dec 2013 14:17:46] Handle_form1 in GATHER
[Fri 13 Dec 2013 14:17:46] Memb_handle_token: handling form1 token
[Fri 13 Dec 2013 14:17:46] Handle_form1 in FORM
[Fri 13 Dec 2013 14:17:46] Memb_handle_token: handling form2 token
[Fri 13 Dec 2013 14:17:46] Handle_form2 in FORM
[Fri 13 Dec 2013 14:17:46] Memb_handle_token: handling form2 token
[Fri 13 Dec 2013 14:17:46] Handle_form2 in EVS

Is there any dokumentation on how spread will behaive on a network fault?

What time can the network be down before one experience problems?

/gh







-- 
[email protected]
Göran Hasse
Boo 229
715 91  ODENSBACKEN
Mob: 070-5530148

_______________________________________________
Spread-users mailing list
[email protected]
http://lists.spread.org/mailman/listinfo/spread-users