Bug: Modifying configure.ac results in error
"Reschke, Sven (VWIF G-TS/P)" <[email protected]>
| Newsgroups | gmane.network.stunnel.user |
|---|---|
| Message-ID | <[email protected]> |
Hallo,
I've encounter a problem when editing the configure.ac.
I've upgraded to Stunnel 5.42, the problem wasn't existent with Stunnel 5.41.
The normal operation is that "./configure" and "make" will run without an error.
So far, so good. Now, if I edit the configure.ac, running again "./configure" and "make", "make" will report:
CDPATH="${ZSH_VERSION+.}:" && cd . && /bin/sh <path_to_stunnel_sources>/stunnel-5.42 /auto/missing aclocal-1.14 -I m4
cd . && /bin/sh <path_to_stunnel_sources>/stunnel-5.42 /auto/missing automake-1.14 --gnu
CDPATH="${ZSH_VERSION+.}:" && cd . && /bin/sh <path_to_stunnel_sources>/stunnel-5.42 /auto/missing autoconf
configure.ac:4: error: possibly undefined macro: AC_MSG_NOTICE
If this token and others are legitimate, please use m4_pattern_allow.
See the Autoconf documentation.
configure.ac:23: error: possibly undefined macro: AC_DEFINE
make: *** [configure] Error 1
Here it doesn't matter what I change in configure.ac. Even the slightest modification results in the error.
After some investigation, running "make" with "-d" showed that it will call auto/missing, because of the newer version of configure.ac.
Comparing aclocal.m4 before and after calling "make" shows, that mainly the lines added between the version 5.41 and 5.42 are missing now (lines #23 - #741).
As I'm not so familiar with the whole compile process, I found a simple hack, which solves the problem for the moment:
Adding these missing lines to a new file named m4/acinclude.m4.
After that, compiling, installing and running Stunnel works fine.
Can someone verify?
If you have questions, I'll try my best to answer them :)
Best Regards,
Sven Reschke
Embedded System SW Developer
G-TS/P
_______________________________________________
stunnel-users mailing list
[email protected]
https://www.stunnel.org/cgi-bin/mailman/listinfo/stunnel-users