Re: Possible stunnel 5.43 bug ?

On 14 Nov 2017, at 11:33 pm, Bezspam <[email protected]> wrote:
> 
>     Hello,
>     I use stunnel on FreeBSD 11.1. I install it from ports. Yesterday I updated to stunnel 5.43. However it stopped working. I investigated the problem and found the issue- instead on all network interfaces, "accept" listens on 127.0.0.1 :
> 
> sockstat -4
> USER     COMMAND    PID   FD PROTO  LOCAL ADDRESS         FOREIGN ADDRESS
> stunnel  stunnel    43945 7  tcp4   127.0.0.1:2222                *:*
> stunnel  stunnel    43945 8  tcp4   127.0.0.1:3128                *:*
> stunnel  stunnel    43945 9  tcp4   127.0.0.1:8080                *:*
> stunnel  stunnel    43945 10 tcp4   127.0.0.1:1616                *:*
> 
>     A workaround is to modify "accept  = 0.0.0.0:3128" explicitly to listen on 0.0.0.0.
>     Is this a bug or expected behaviour?
> 
>     Best regards,
>     Bez Spam

I had the same issue after upgrading to 5.43 - nothing could connect. No information about connections was in the log. It started up OK, but nothing happened.

Didn’t get to investigate it like you did Bez, I had to quickly go to back to version 5.42 to get things working again. Compiled same way, same configuration - only difference was upgraded to version 5.43.

Mac OS X 10.7.5

James.

_______________________________________________
stunnel-users mailing list
[email protected]
https://www.stunnel.org/cgi-bin/mailman/listinfo/stunnel-users