Re: Authentication

Hi Paul,

IMO, this should be set in your application, not in stunnel.conf.

Flo

On Fri, Apr 20, 2018 at 3:58 PM, Paul Muller <[email protected]>
wrote:

> When I first setup stunnel, I changed my software to reflect the
> [gmail-smtp] entries in my configuration file.  When I tried to send an
> email from my application I received the following message:
>
>
>
> “No Email sent, Error 535-5.7.8 Username and Password not accepted.”
>
>
>
> Then I remarked out the authentication credentials in my software.  When I
> tried to send an email I received the following message:
>
>
>
> “No Email sent, Error-5.5.1 Authentication Required.”
>
>
>
> My question is, can place my authentication credentials in the
> “stunnel.conf” file?  And if so, where?
>
>
>
> Thanks,
>
>
>
>
>
> [image: logo1]
>
>
>
> *Paul A. Muller · Systems and Networking Consultant*
> *Earnest & Associates · Profitability Improvement Specialists*
> Voice: 305.822.5353 x354 · Fax: 305.822.5848
> Email: [email protected] · Web: earnestassoc.com
> <http://www.earnestassoc.com/> · Twitter: @earnestassoc
> <http://twitter.com/earnestassoc>
>
>
>
>
>
> _______________________________________________
> stunnel-users mailing list
> [email protected]
> https://www.stunnel.org/cgi-bin/mailman/listinfo/stunnel-users
>
>

_______________________________________________
stunnel-users mailing list
[email protected]
https://www.stunnel.org/cgi-bin/mailman/listinfo/stunnel-users