Re: How to configure stunnel client on Mac

No ideas on this one from the stunnel community? Hmmm ...

More information ...

After going through the installation steps shown below, I have new files in

/usr/local/etc/stunnel

including stunnel.pem, etc. I've copied my stunnel.conf and certificate files to
this folder, but again, not sure how to get stunnel to start as a service with
MAC.

--Mark

-----Original Message-----
From: Mark Foley <[email protected]>
Date: Mon, 30 Apr 2018 14:04:52 -0400
Organization: Novatec Software Engineering, LLC
To: [email protected]
Subject: [stunnel-users] How to configure stunnel client on Mac

I've successfully set up stunnel for Windows and Linux clients. Now to set up
for Mac. I've gone to the website http://macappstore.org/stunnel/ and followed
the instructions there which are:


1. Press Command+Space and type Terminal and press enter/return key.

2. Run in Terminal app:

    ruby -e "$(curl -fsSL https://raw.githubusercontent.com/Homebrew/install/master/install)" < /dev/null 2> /dev/null
    and press enter/return key.

3. Run:
    brew install stunnel

And then it says, "Done! You can now use stunnel."

Well, not exactly. Where do I put my stunnel.conf and certificate.pem? How do I
make stunnel run automatically at boot time?

The web instructions aren't very complete. Need additional assistance.

THX --Mark

_______________________________________________
stunnel-users mailing list
[email protected]
https://www.stunnel.org/cgi-bin/mailman/listinfo/stunnel-users

_______________________________________________
stunnel-users mailing list
[email protected]
https://www.stunnel.org/cgi-bin/mailman/listinfo/stunnel-users