Windows Server 2012 R2

Hello,
I have joined the mail group in the hope that someone can help with problems I am having running on our Server machine.
I downloaded "stunnel-5.45b6-win64-installer" and installed it on our Server.
When I run the executable I get:

2018.05.17 12:48:33 LOG5[main]: stunnel 5.45 on x64-pc-msvc-1913 platform
2018.05.17 12:48:33 LOG5[main]: Compiled/running with OpenSSL 1.1.0g  2 Nov 2017
2018.05.17 12:48:33 LOG5[main]: Threading:WIN32 Sockets:SELECT,IPv6 TLS:ENGINE,OCSP,PSK,SNI
2018.05.17 12:48:33 LOG5[main]: Reading configuration from file stunnel.conf
2018.05.17 12:48:33 LOG5[main]: UTF-8 byte order mark detected
2018.05.17 12:48:33 LOG5[main]: Configuration successful

The shortcut
[cid:[email protected]]

I was expecting to get a GUI interface but that does not happen. Can someone tell me what is going wrong. I feel as though I have missed something obvious.

Daniel McArdell | Senior Analyst Programmer | Products & Technology | BNZ<http://www.bnz.co.nz/>

L6 Custom House, 17 Whitmore St, Wellington 6011

DDI +64 4 4746679 (extn 76679) | F +64 4 4746023 | M +64 29 2220451 | E [email protected]<mailto:[email protected]?Subject=>





CAUTION - This message may contain privileged and confidential information intended only for the use of the addressee named above. If you are not the intended recipient of this message you are hereby notified that any use, dissemination, distribution or reproduction of this message is prohibited.

This email was sent by the Bank of New Zealand. You can contact us on 0800 ASK BNZ (0800 275 269). Any views expressed in this message are those of the individual sender and may not necessarily reflect the views of Bank of New Zealand.

_______________________________________________
stunnel-users mailing list
[email protected]
https://www.stunnel.org/cgi-bin/mailman/listinfo/stunnel-users